FRP is produced using pultrusion technology and grew to become the commonest construction material for cooling towers because it gives decrease costs and requires much less maintenance in comparison with bolstered concrete.
FRP Cooling Tower Fill
Honeycomb PVC Fills are used for extended contact area having excessive heat switch efficiency. The crossing of air and water streams in close proximity, which creates a diffuesed turbulence conductive to evaporation and environment friendly heat transfer. A pre-eminent quality and lengthy life fill consists of modular block of PVC honey combs development to create extended contact time of sizzling air with water for optimum heat transfer. The air stress drop by means of the fill is negligible. The fills available in numerous flute size like 6mm, 12 mm, 19 mm and 1.2 mm thichness.
FRP Cooling Tower Nozzles
Common fill consists of Honeycomb PVC Movie type splash deck is modules with high resistant to corrosion and highly efficient for heat switch water distribution system. The recent water is raised by scorching water riser and taken inside by a PVC hot water header inside. Department distribution pipes fitted with Polypropylene Splash cups / non clogging nozzles are related to sizzling water heater and uniform water distribution over whole fill is achieved. It is totaly upkeep free distribution.
FRP Cooling Tower Drift Eliminator
To reduce perform losses by way of entrainment of moisure drops within the stream by specifically designed drift elimiator fabricated from PVC Fills. Extra PVC eliminator is offered in large capacity cooling towers.
FRP Cooling Tower Motor
Particular low RPM completely enclosed motors of vertical, Flange sort with enlarged and treaded shaft and sealed high is equipped with the cooling tower. The motor can be weather proof and in IP-fifty five building.
FRP Cooling Tower Supports and Hardware:
All parts like tower supports, motor helps, leg supports, and so on., are either sizzling dip galvanized or epoxy coated. Hardware is Galvanized Steel. Stainless Steel or Phosphor Branze hardware could be supplied on request at extra value.
FRP Cooling Tower Fan
The fan consists of axial propeller fan blades of special alloy aluminium blades of aero dynamic designed axial movement sort to achieve excessive efficiency. Adjustable pitch blades are used for maximum utilization of applied horsepower and related to a standard Aluminum Alloy Hub. The fan is dynamically balanced. FRP fan set may also be provided on request at extra cost.
FRP Cooling Tower Energy Fans
A new generation, cutting-edge cooling tower fans, the energy economy concept. Built with uncompromising worldwide high quality standards. Our fans are combination of performance, energy, endurance and reliability.
Kinds of Frp Cooling Towers:
1. FRP Square Type Cooling Tower
2. FRP Bottle Shape Cooling Tower
three. FRP Seamless Cooling Tower
FRP Cooling tower casing is product of selected grade materials of Fibre Glass Strengthened Plastic and resins. Extra embossing is done for extra power. FRP casing and basins are designed to withstand extreme vibration, high wind load and to resist corrosion. Water basin is totally leak proof, which avoids spillage and seepage of water. It’s of deep sump to ensure most water level always and made of FRP with additional stiffening take care of additional water weight. We manufacture Bottle Shape Cooling Towers, Sq. Form Cooling Towers and Seamless Cooling Towers
Energy Saving: FRP fans are most efficient, consumes upto 30% less power than typical aluminum alloy / FRP blades. Thus saving in operational cost is enormous.